Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
99-00962-20 REV C0
iii | IMPORTANT INFORMATION
CAUTION
• Make sure that the weight of your flat-panel display is minimum
80 lb. (36.3 kg) and maximum 160 lb. (72.6 kg). For a list of flat-panel displays
supported by your SMART Mobile Stand, see
http://www2.smarttech.com/st/en-US/Support/FlatPanel/MobileStandPanels
.
• To prevent damage to a 60" (152.4 cm) or larger flat-panel display when
it is installed with a SMART Board for Flat-Panel Displays interactive overlay,
make sure that you install the included clevis pin as instructed in this guide
(see pag 13).
• To prevent damage to your power and extender cables, secure them to your
mobile floor stand as instructed in the SMART Mobile Stand for Interactive
Displays Textless Installation Instructions (document 132293
at www.smarttech.com/support
).
• To prevent crushing additional product cables between your flat-panel display
and the SMART Mobile Stand’s speaker panel, follow the path of the installed
cable harness.
• Do not suspend additional objects from, or add any extra weight or excessive
pressure to, your SMART Mobile Stand’s brackets (other than the products
indicated in this guide). SMART designed these brackets to support only
the combined weight of a flat-panel display, interactive overlay or display
frame, laptop computer and optional laptop shelf, during normal use.
Any other weight hung from these brackets may cause the stand to tip.
• If you install additional audio or video cables other than those provided
with your SMART Mobile Stand, SMART Board interactive display frame,
SMART Board for Flat-Panel Displays interactive overlay, or as part of an
adapter kit, SMART assumes no responsibility and you are solely responsible
for any damage incurred to your SMART Mobile Stand, its cabling or
other devices.
• Your SMART Mobile Stand is designed for standard ramp access. At least two
people are required to move your unit up or down a ramp. Moving your unit up
or down a ramp with a steep incline may cause your SMART Mobile Stand to
tip.
• Never operate your SMART Mobile Stand immediately after moving it from a
cold location to a warm location. Allow the unit to reach room temperature
before operation to prevent possible product damage. The operating
temperature range is from 41°F to 86°F (5°C to 30°C) with up to 80% relative
humidity, non-condensing. The shipping and storage temperature range
is from -40°F to 140°F (-40°C to 60°C).
• Do not place your SMART Mobile Stand in hot locations, such as near
heating equipment.