Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
48 | MODEL FSSBID 100H: CONNECTING DEVICES INSIDE YOUR SMART MOBILE
STAND’S CABINET
99-00962-20 REV C0
Connecting a DVD/Blu-ray Player or VCR
Your SMART Mobile Stand supports audiovisual devices, including a DVD/Blu-ray
player or VCR. Internal connections provide support for an S-video device with stereo
audio, and a composite video device with stereo audio.
CAUTION
If you install additional audio or video cables other than those provided with your
SMART Mobile Stand, SMART Board interactive display frame, SMART Board
for Flat-Panel Displays interactive overlay, or as part of an adapter kit, SMART
assumes no responsibility and you are solely responsible for any damage
incurred to your SMART Mobile Stand, its cabling or other devices.
IMPORTANT
• The following procedures are generic instructions, and your DVD or Blu-ray
player or VCR’s connection panel might not resemble the illustrations or color
codes referenced in this guide. Refer to the documentation included with your
device for specific connection instructions.
• For some DVD and Blu-ray players, you might choose to purchase a separate
HDMI cable to replace cables
A05 and V02. Install this HDMI cable along
the same path as cables
A05 and V02. See page 41 for details on connecting
the other end of these cables to your flat-panel display.
TIPS
• Install your DVD or Blu-ray player on the top shelf, or the second highest
rack mount position.
• Install your VCR on the lowest shelf in your SMART Mobile Stand’s cabinet.
To connect your
DVD/Blu-ray player
1. Connect the two-plug RCA cable A05, or your HDMI
cable, as follows:
– Connect the red audio plug to your DVD
or Blu-ray player’s appropriate red receptacle,
which is typically labeled
R.
– Connect the white audio plug to your DVD
or Blu-ray player’s white receptacle,
which is typically labeled
L.
NOTE
You previously connected the other end of this
cable to your SMART Hub SE240 (see page 44).
2. Connect S-Video cable
V02 to the appropriate receptacle on your DVD
or Blu-ray player. This receptacle is typically labeled
S-Video.
S-Video
Male
Cable
V02
2 × RCA
Cable A05