3Com FSSBID 100 Gas Grill User Manual


 
ii | IMPORTANT INFORMATION
99-00962-20 REV C0
Use the SMART Mobile Stand’s three grab bars to move the unit.
Do not press, pull or push on the flat-panel display, interactive overlay or
display frame, cabinet, doors, rear access panel plastics or vertical brackets.
Before moving your SMART Mobile Stand, make sure that you unlock the
casters. These casters are designed to roll on common indoor surfaces. While
you move the unit, your view may be partially obstructed. Be aware of
surrounding obstacles.
Do not move your SMART Mobile Stand while external cables are connected
or when the power is on.
You must connect the USB cable that came with your SMART Mobile Stand
to a computer that has a USB 2.0 compliant interface and that bears the USB
logo. In addition, the USB source computer must be compliant with
CSA/UL/EN 60950 and bear the CE mark and CSA and/or UL Mark(s)
for CAS/UL 60950. This is for operating safety.
Ensure that any cables extending across the floor to your SMART Mobile
Stand are properly bundled and marked to prevent a tripping hazard.
Do not stand (or allow children to stand) on a chair to touch the surface
of your flat-panel display. Instead, rotate your SMART Mobile Stand’s
height-adjustment handle to lower your display to the appropriate height.
Do not climb or ride (or allow children to climb or ride) on your SMART Mobile
Stand. Climbing or riding on your SMART Mobile Stand could result
in personal injury or product damage.
(For European customers only)
Your SMART Mobile Stand should be used only with European TN and TT
power distribution systems.
It is not suitable for older, IT-type power distribution systems found in some
European countries. “This system (IT-type) is widely used isolated from earth,
in some installations in France, with impedance to earth, at 230/400V, and in
Norway, with voltage limiter, neutral not distributed, at 230V line-to-line.”
(IEC 60950:1999)
Contact qualified personnel if you are uncertain about the type of power
system available where you are installing your SMART Mobile Stand.
To reduce the risk of fire or electric shock, do not expose your SMART Mobile
Stand to rain or moisture.
Your SMART Mobile Stand is designed to operate with a maximum power
consumption of 1200 W. Exceeding this consumption could result in fire,
personal injury or death.