Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
22
Models QS10 & QS22Operating Procedures
Step 5
Carefully remove the grease tray partition. Take it to
the sink for cleaning.
Figure 21
Note: For installation of the grease tray partition,
carefully reverse the above steps.
Closing Procedures
Step 1
Raise the upper cook surface to the raised position.
Step 2
Turn the power switches to the OFF position.
Figure 22
Step 3
Wipe the release material sheet thoroughly while still
attached to the upper cook surface, using the rubber
wiper squeegee.
CAUTION: The upper cook surface and
release material sheets are very hot. To prevent
burn injuries, wear protective gloves and use ex-
treme care when performing this procedure.
Step 4
Holding a dry towel in both hands, remove the upper
release material clips by pulling up on the tab to
snap the clips off the bar.
Step 5
Holding the dry towel in both hands, remove the
release material.
Step 6
Take the release material clips and the release
retainer to the sink for cleaning.
Step 7
Repeat steps 1 through 4 for the other upper platen
on the QS22.
Step 8
Clean the upper cook surface(s) with the special
rubber squeegee.
Note: DO NOT use metal scrapers, abrasive pads,
screens or wire brushes to clean the upper cook
surface.
CAUTION: Protect eyes, lungs, and all
parts of the body from potential harm when
using any chemical cleaner.
Step 9
To clean the upper cook surface, use a spray bottle
of full strength cleaner/degreaser (i.e., Sizzler Grill
Bun and Toaster Cleaner, a Kay Chemicalr
product). Hold the bottle 6" (152 mm) away and mist
the entire upper cook surface, starting at the front.
(Use a cleaner that will not damage aluminum.)
Mist one ounce of cleaner over each upper cook
surface and two ounces on the lower cook surface.
Let the cleaner soak for 3-5 minutes. (Note: One
ounce of cleaner equals approximately thirty
squirts.)