Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
GAS LINE
Remove the 3/8” flare fitting that
attaches the propane hose from the
Manifold block inside of the pedestal
and replace with an approved 10’
Natural Gas Hose neoprene hose.
Part # NGHOSE
REMEMBER TO LEAK CHECK ALL
FITTINGS AND ORIFICES AFTER
ALL OF THE CONVERSION IS
COMPLETED, LEAK CHECK ALL
FITTINGS AND TEST FIRE ALL
BURNERS TO ENSURE PROPER,
SAFE OPERATION.
MAINTENANCE
Burner Inspection: Please inspect these burners once a year.
Periodically inspect the burners for blockage or corrosion. These burners can be cleaned using a small piece
of wire and a wire brush. Be careful not to damage the ceramic spark electrode. Have the burner replaced if
there are any signs of deterioration.
BURNER REMOVAL FOR CLEANING
1. Ensure the gas supply is off and grill is cool.
2. Remove Cooking Grids and Upper Flavor Shields.
3. Remove the burner mounting screw located at the very back of burner near the rear of the firebox.
4. Remove burners by lifting up and out of firebox on an angle. Repeat for all burners.
5. Clean the outside of the burners with a Brass Bristle wire brush and make sure all gas ports are clear.
Use a straight coat hanger to clear any obstructions.
6. Use a flashlight to look into the venturi end of the burner to check for blockages. If necessary, use a
straight coat hanger to clear any obstructions.
7. Inspect and clean the venturi end of the burner by removing the venturi set screw on the end of the
burner and removing the venturi shutter. Once removed, make sure the burner is thoroughly cleaned and
the venturi shutter is re-installed with an opening of 1/8” for Natural Gas and ¼” for Propane. (NOTE:
ensure that the venturi set screw is tight after setting the correct air shutter opening.
8. Re-install and secure burner.
9. Re-mount flame tamers and cooking grids.
10. Light each burner to ensure they are operating correctly.
Note: When installing burners, it is very important to center the burner over the gas orifice. You should look
under the main control panel with a flashlight once installed to make sure they are in the proper position.
Failure to clean and install burners correctly could result in fire or explosion.
Remove
Propane hose
and regulator
assembly and
Install new
Natural gas
Hose