Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Owner’s Manual Page 50
Owner’s Manual Cal Flame Entertainment System
VCR Controls
12. VCR POWER Button
This button is used to turn the unit on and off.
13. “REW” REWIND Button
If this button is pushed while the tape is stopped, the tape will rewind. If this button is pushed while the tape
is playing, the VCR will go into rewind search mode. For more information on search feature of the VCR,
consult VCR Owner’s Manual.
14. PLAY Button
Press this button to activate play mode while a tape is loaded into the VCR. This button may also be used
to disengage search and pause modes. For more information, consult the VCR Owner’s Manual.
15. “F.FWD” FAST FORWARD Button
If this button is pushed while the tape is stopped, tape will fast forward. If this button is pushed while the
tape is playing, the VCR will go into fast forward search mode. For more information on search feature of
the VCR, consult the VCR Owner’s Manual.
16. STOP Button
Press this button to stop the video tape.
17. REPLAY Button
Press this button will rewind the video tape and immediately begin playback when the video tape is fully
rewound.
Operation
1. Point the remote control directly at the TV Monitor.
2. Press the Red Power Button located at the top left side of the remote control.
3. Allow a few seconds for the TV monitor to warm up before pressing any other buttons.
4. Once on, the TV monitor will display a small icon at the lower left side signifying which mode the TV is
currently in.
5. Press the “SELECT” button located at the top right side of the TV remote control until the icon
“COMPOSITE VIDEO” is displayed on the screen of the TV monitor. This will allow the TV Monitor to
accept the signal from the DVD player.
6. When an antenna, cable or satellite system is connected to the coaxial cable on the right front side of the
spa, you will be able to receive live TV signals by pressing the “SELECT” button until the
“COMPOSITE TV” icon appears on the TV monitor. Allow a few second for the TV tuner to acquire the
new signal prior to switching channels.
7. Press the right “VOL” button to adjust the volume up to “80” as displayed on the screen. This will allow
the Stereo system to receive enough volume to reproduce the audio signal without distortion.
NOTE
:You will not be able to hear audio form the TV Monitor itself. All audio signals for the TV or DVD
are only acquired through the stereo when programmed to 88.7FM.
Adjusting the Picture
When watching the TV programs, the quality of the picture can be adjusted to suit your taste.
1. Press MENU. The main menu appears.
2. Press SELECT VIDEO. The video source appears. Press this button to access the AUDIO/VIDEO input
jacks.
3. Select CLOSED CAPTION and then press ENTER.
Closed captioning lets you display the audio portion of a program as text on the TV screen. This is useful
to the hearing impaired or anyone who wants to watch a program without a sound.