Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
MODEL #TWT WORKTABLE ASSEMBLY
Required Tools: Adjustable Wrench
This unit is designed to be used as a worktable for the preparation of turkeys for frying and for
draining afterwards. It is not intended for any other use. It is to be used only with Deep Fryer
Turkey Packages. This worktable assembly is NOT for use with Model #3018.
1. Stand worktable and cooker
side by side, as in the
illustration, on a level, sturdy,
non-combustible surface.
2. Hold the side of the worktable
with the brackets next to the
cooker. Line up one pair of the
holes in a bracket so that one
hole is above the cooker ring
and one is below. Choose to
use the pair of holes which will
allow the worktable to be level.
Some models of cookers will
use the top sets of holes in the
brackets, while some models
work best with the lower sets
of holes. Make sure that the
work surface will be flat when
assembly is complete.
3. Slide the U-bolts around the
top ring of the cooker and
through the holes in one of the
brackets. Do the same for the
other bracket.
4. Screw one of the 1/4” wing nuts onto each end of a threaded U-bolt and wrench tighten. Make
certain that each U-bolt and wing nut assembly is tightened so that the unit will stand sturdily with
no sway when the unit is attached.