Weber E210 Gas Grill User Manual


  Open as PDF
of 72
 
24 WWW.WEBER.COM
®
STORAGE AND/OR NONUSE
For grills that have been stored or left unused for a while, it is important to follow these guidelines:
• ThegasmustbeturnedoffatthenaturalgassupplywhentheWeber
®
gas grill is not in use.
• IfstoringtheWeber
®
gas grill indoors, rst DISCONNECT the gas supply.
• TheWeber
®
gas grill should be checked for gas leaks and any obstructions in the burner tubes before it is
used. (Refer to “ANNUAL MAINTENANCE.”)
• Checkthattheareasunderthecontrolpanelandtheslide-outgreasetrayarefreefromdebristhatmight
obstruct the ow of combustion or ventilation air.
• Thespider/insectscreensshouldalsobecheckedforanyobstructions.(Referto“ANNUALMAINTENANCE.”)
ANNUAL MAINTENANCE
3
4
1
5
2
BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Reinstall Manifold
Youwillneed:APhillipsscrewdriver,two7/16"wrenches.
A) Alignvalveswithburnertubes.Usingtwo7/16"
wrenches, install bolts and nuts that secure manifold
to cookbox (1).
B) With a Phillips screwdriver, install screws and washers
that secure manifold to front cross brace (2). If
manifold was properly reinstalled, valves will now be
fully seated inside burner tubes.
m CAUTION: The burner tube openings
(3) must be positioned properly over
the valve orices (4).
m WARNING: You should check for
gas leaks every time you disconnect
and reconnect a gas tting. Refer to
CHECKING FOR GAS LEAKS.
C) Replace cookbox components (not pictured).
Reinstall Control Panel
You will need: A Phillips screwdriver.
A) Guide the two wires on back of control panel over
front cross brace and down into cabinet(5).
B) Align valve stems with holes in control panel. Position
top edge of control panel on tabs of frame assembly.
Push control panel down into position.
C) Fasten control panel with screws.
D) Place control knobs onto valve stems.
E) Connect the wires to the igniter module. Snap wires
back into wire clips on inside left panel. Refer to
“MAINTAINING THE ELECTRONIC CROSSOVER
®
IGNITION SYSTEM” for proper positioning.
m WARNING: Make sure that all parts
are assembled and hardware is fully
tightened before operating the grill.
Your actions, if you fail to follow this
product warning, may cause a re,
an explosion, or structural failure
resulting in serious personal injury or
death as well as damage to property.
 previous next