Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
18 WWW.WEBER.COM
®
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
PROBLEMS SOLUTIONS
Burner does not ignite when you push the igniter
button.
Be sure that there is gas ow to the burners by attempting to match light your burners. Refer to “MAIN BURNER
IGNITION—Lighting with a Match.” If match lighting is successful, the problem lies in the ignition system. Refer to
“MAINTAINING THE ELECTRONIC CROSSOVER
®
IGNITION SYSTEM.”
Be sure that wires are correctly inserted into terminals on igniter module. Check that the wires are connected to
terminals on igniter button under the control panel. Refer to “IGNITER MODULE WIRE GUIDE.”
If a new battery is installed, conrm that battery’s plastic wrapping has been removed. Verify that the battery is in good
condition and has been installed correctly. Refer to “MAINTAINING THE ELECTRONIC CROSSOVER
®
IGNITION
SYSTEM.”
Burner does not ignite, or ame is low in
high (
) position.
Fuel hose could be bent or kinked. Straighten fuel hose.
Burner ame pattern is erratic.
Flame is low when burner is on high (
) position.
Flames do not run the whole length of the
burnertube.
Clean burner ports that run down the entire length of burner tube. Refer to “ANNUAL MAINTENANCE.”
Burners burn with a yellow or orange ame, in
conjunction with the smell of gas.
Inspect spider/insect screens for possible obstructions. (Blockage of holes.) Clean spider/insect screens.
Refer to “ANNUAL MAINTENANCE.”
Experiencing are-ups.
m CAUTION: Do not line the slide-out
grease tray with aluminum foil.
Grill must be preheated with all burners on high for 10 to 15 minutes.
Clean the cooking grates and Flavorizer
®
bars thoroughly to remove grease. Refer to “ROUTINE MAINTENANCE.”
The slide-out grease tray may be dirty and is not allowing grease to ow into catch pan. Clean slide-out grease tray.
Inside of lid appears to be “peeling.”
(Resembles paint peeling.)
The inside of the lid is porcelain enamel or stainless steel. It is not painted. It cannot “peel.” What you are seeing is
baked-on grease that has turned to carbon and is aking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to
“ROUTINE MAINTENANCE.”
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.