Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
16 WWW.WEBER.COM
®
Summary lighting instructions are inside
the cabinet door.
MAIN BURNER IGNITION & USAGE
2
5
1
4
3
MAIN BURNER IGNITION
Electronic Crossover
®
Ignition System
The electronic Crossover
®
ignition system ignites burner
1 with a spark from the igniter electrode inside the Gas
Catcher™ ignition chamber. You generate the energy for
the spark by pushing the igniter button. You will hear the
igniter clicking. Burner(s) 2 (and 3) can be lit after burner1
is lit.
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting
the grill’s burners, or not waiting ve
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive are-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned off
(2). Check by pushing control knobs in and turning
them clockwise until they stop.
C) Turn the gas supply valve on (3).
D) Push burner 1 control knob in and turn it
counterclockwise to start/high ( ) position (4).
IMPORTANT: Always ignite burner 1 rst. The other
burner(s) ignite from burner 1.
E) Push and hold in the igniter button (5). You will hear
the igniter clicking.
F) Check that burner 1 is lit by looking through the
cooking grates. You should see a ame.
m WARNING: Do not lean over the open
grill.
m WARNING: If burner 1 fails to ignite
within ve seconds, stop, turn the
burner control knob to off and wait
ve minutes to allow the gas to clear
before you try again or light with a
match.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3).
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
METHODS OF BURNER
IGNITION
There are two ways to ignite
burner 1. The first is by using
the electronic Crossover
®
ignition system built into your
grill. The second is with a
match.
Next are the steps for igniting
your grill using the electronic
Crossover
®
ignition system.
On the following page are
steps for igniting your grill
with a match.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill with the electronic
Crossover
®
ignition system.
Do not confuse this plastic
with the battery label.