Status Acoustics 2 Outdoor Cart User Manual


 
Internet Service Node (ISN) 2.0 Release Notes
Page 24
Identifier Severity
Headline Release-note enclosure
CSCma16843 4
Ports not set for prerouted calls
will cause AS to go Out of
Service
If the preroute ports are not set, the first
prerouted call will make the AS go Out of
Service indefinitely. Possible Solution:
Restart the Application Server and add the
necessary ports.
CSCma17032 4
IP address of GW is passed
when the ANI is blank by the VB
When the VB receives a blank ANI, VB
substitutes the GW's IP address in the ANI
field. This should not happen. The VB should
pass the ANI field unchanged.
CSCma17495 3
GD and Menu should repeat the
prompt during an invalid or no
entry
GD and Menu should repeat the prompt (or
menu prompt) when there is an invalid entry
or no entry timeout. Currently an error
message would be played out to the caller to
repeat the entry, however the menu prompt is
not repeated to the caller.
CSCma17676 2
VB send out of resource RAS
message to GK after 1 call
Symptom: Some Voice Browsers can
process no more than 1 or 2 simultaneous
calls.
Conditions: When you use ISN inbound call
routing via gatekeeper, the ISN voice browser
sends 'out-of-resources' indication to the
gatekeeper after processing 1 call. When all
the voice browsers show 'out-of-resources',
the gatekeeper will still (successfully) send
all calls to 1 of the voice browsers, even
though it shows out of service. This bug
decreases the capacity of your ISN to
((1/numberOfVoiceBrowsers)*100) percent.
Workaround: Use gateway dial-peer inbound
call routing instead of gatekeeper inbound call
routing.
CSCma17693 3
Digit buffer should be flushed
when call transferred
The digits collected by the Voice Browser
should be flushed when it transfers a call.
Otherwise when the call is taken back for IVR
treatment, they start acting on the new IVR
script. Workaround is to do a "get digits" to
collect and throw away any left over entries,
using a "no entry timeout" of 0.
CSCma18166 4
Media library type=N is not
supported
The user documentation describes a setting
"N" for the media library type; it is not
supported.