Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
34
Vent System:
The fireplace and venting system should be inspected before initial use and at least annually by a qualified field
service person. Inspect the external vent cap on a regular basis to make sure that no debris is interfering with the
airflow. Inspect entire venting system to ensure proper function.
Refer to the VENT INSTALLATION section for removing and reinstalling vent components.
Glass Door:
Periodically clean the glass door as necessary. You should thoroughly clean the inside of the glass door after using
the fireplace for the second or third times.
When cleaning the glass, remember:
• Do not remove the glass when hot. Allow glass to cool before removal.
• NEVER use abrasive materials.
• Keep children and pets a safe distance away.
• Never operate the fireplace without the glass door properly secured.
• Never operate the fireplace if the glass is broken.
• Replace any glass that is chipped, cracked, or broken. Replacement glass door assemblies MUST be supplied by
the fireplace manufacturer -No substitute materials may be used. Refer to Glass Removal section.
• Handle glass door with care to avoid striking or scratching it on hard objects.
To clean glass door, follow “Glass Removal” procedure outlined in the FINAL INSTALLATION section. Film
deposit on the inside of the glass should be cleaned off using a nontoxic, non-corrosive, non-abrasive, mild-cleaning
solution. Simply apply an adequate amount to the glass and wipe off with a damp cloth. After all maintenance has
been completed, re-install glass door.
Logs
Leave logs installed in the fireplace for cleaning. Vacuum surface of the logs with a brush attachment. If logs must
be removed for cleaning, handle carefully by holding gently at each end. Gloves are recommended to prevent skin
irritation from ceramic fibers. If skin becomes irritated, wash gently with soap and water. Vacuum surface of logs
with brush attachment or brush logs with a soft bristle brush (i.e. clean, dry paintbrush). To place logs back in the
fireplace, refer to “Log Placement” found in the FINAL INSTALLATION section.
NOTE
Do not use cleaning fluid to clean logs.
Rock Wool
Make sure the rock wool is place according to the section Rock Wool Placement on page 26. You may be required
to add rock wool if the quantity is low.