Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
PART #4521777 (03/19/08)
GARLAND ELECTRIC CLAMSHELL GRILL WITH PRODUCT RECOGNITION MODEL MWE3W INSTALLATION/OPERATION MANUAL
Page 7
CLEANING & MAINTENANCE continued
13. Rinse the upper platens with a dripping wet grill cloth.
RINSE PLATEN EDGE THOROUGHLY, THEN WIPE DOWN
BACK EDGE OF PLATEN.
14. Carefully pour small quantities of lukewarm water
onto the grill while brushing the surface, backsplash,
and bullnose with a LONGLIFE™ pot brush or
equivalent high-temperature brush. Continue until the
water no longer boils away and the grill remains wet.
Squeegee dry.
Caution: Ice, cold water, or large quantities of water must
never be applied to the grill plate or upper platen. Severe
damage to the grill will occur!
15. Clean the release sheets as follows:
16. Place the sheets on the lower grill. Scrub both sides of
the sheets with the same McD NO-SCRATCH™ Pad used
on the grill.
Note: It is generally not necessary to apply additional
product to the NO-SCRATCH™ Pad. If the pad is not wet
enough rewet with a small amount of water, if no cleaner
is left.
a. Rinse both sides of the sheets with a wet grill cloth.
b. Rinse the lower grill by flooding the surface twice
with lukewarm water. Squeegee after each rinse.
17. Wipe the lower grill surface, backsplash, bullnose, and
hood with a clean, damp grill cloth.
AFTER CLEANING: Apply a thin coat of fresh shortening
to the lower grill surface only. Wipe down the surrounding
areas. Empty, wash, rinse, and replace the grease troughs.
Note: Repeat this procedure to clean additional grills.
Reverse NO-SCRATCH™ Pad, and use clean side.
CLEANING AFTER EACH RUN OF PRODUCT:
Using grill scraper, scrape grease on lower grill plate from
front to back only. Do not scrape across the rear of the
lower grill plate with grill scraper. Use wiper squeegee
to clean release material sheet on upper platen in a
downward motion.
Hold handle at a slight upward angle with wiper end
facing downward. Do not press hard against the release
material sheet to prevent scratching or tearing.
Push the grease at the rear of the lower grill plate into the
grease cans using the wiper squeegee only. Do not use the
grill scraper for this step.
Warning: Grill Temperatures will cause severe skin burns.
Use the grill cloth to clean back splash and bullnose areas
as needed during operation.
Note: To increase life of release material sheet, wipe down
with folded grill cloth four (4) times every hour.