Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
INSTALLATION/OPERATION MANUAL GARLAND ELECTRIC CLAMSHELL GRILL WITH PRODUCT RECOGNITION MODEL MWE3W
PART #4521777 (03/19/08)Page 14
DESCRIPTION OF GRILL CONTROL
POSSIBLE ERROR MESSAGES
GRILL PROBE ERROR – A grill temperature probe circuit error for temperature zone (Front, Middle, or Back) has occurred.
PLATEN PROBE ERROR – An upper platen temperature probe circuit error has occurred.
HEATER ERROR – Occurs when the controller does not detect a temperature rise in six (6) minutes.
HIGH TEMP – Occurs when the controller senses a temperature of 465˚ F (241˚ C).
CHECK REED SWITCH / USE FLAT COOK – One or more of the Reed Switches are out of adjustment. User will only be
able to cook FLAT menu items.
ERROR COMMS - A communications error has occured between the Motor Speed Control and the Main Control.
CHECK PLATEN LEVEL – Occurs if the calibration difference between the front and rear is greater than the minimum
allowance, but less than the maximum allowance. Product Recognition (Auto) is DISABLED.
PLATEN NOT LEVEL* – Occurs if the calibration difference between the front and rear is greater than maximum
allowance. Product Recognition (Auto) and manual cooking is DISABLED. Flat Menu cooking is ONLY allowed.
* Platen Auto-Calibrate
If CHECK PLATEN LEVEL is displayed, perform the
following steps:
1. PRESS AND HOLD the and buttons for 3 seconds.
The control will display AUTO GAP FORCE.
2. PRESS the button. “NO” will flash on the display.
PRESS the button to change it to “YES.”
3. PRESS the button. The platen will immediately lower
and reset its internal measurements. Upon completion,
the platen will rise. If the error message does not return
continue operating normally. If the error message
persists, level the platen, as shown on page 30.
Power Button – PRESSING and HOLDING the
Power button for 2 seconds will either turn
the controller on or off.
AM/PM Button – In normal operating mode,
toggles between the AM menu library and
the PM menu library.
AUTO/MAN Button – In normal operating
mode, toggles between Automatic Product
Recognition and Manual Cooking.
Up Arrow Button – In any mode, increases
the value of the flashing cursor character in
the display
Down Arrow Button – In any mode,
decreases the value of the flashing cursor
character in the display
Right Arrow Button – In any mode, scrolls
forward through a list
Left Arrow Button – In any mode, scrolls
backward through a list
Enter Button – In the normal operating
mode, this button is not active. In the
Programming Mode, used to lock in the
values shown on the display.
Program Button – In the normal
operating mode, pressing and holding the
PROGRAM button for 3 seconds enters the
Programming Mode.
Temp Button – In the normal operating
mode, displays the set temperature and the
actual temperature.
Speed Key – In the normal operating mode,
used to change cook time. Also used to enter
Probe Calibration Mode.
Standby Button – In the normal operating
mode, places the grill in Standby Mode.
call your local authorized service agent.