Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
18
Cleaning The Quick Set Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if
you have trouble igniting grill.
1. Turn gas off at control knobs and LP tank.
2. Remove cooking grate and drip vaporiser bar.
3. Discard used briquets before removing burner and briquet grate.
4. Under grill remove grease cup, (unscrew ignitor button and remove
battery on electronic ignition models), disconnect short ignitor wire (A) and
clips from burner (B). To remove clips pull down on large end of clip
attached to the valve, turn away from valve, rotate upward and remove
small end of clip from burner tube.
5. Inside grill remove burner assembly and briquet grate (C), clean ceramic
portion of electrode with rubbing alcohol and a swab. Remove scale from
briquet grate, replace if necessary.
6. Clean outside of burner with soap and water. Lay burner upside down on
flat surface, insert garden hose to force water through tubes. Make sure
water comes out of all burner holes. Open clogged holes with a thin wire.
Shake out excess water and examine holes. Due to normal wear and
corrosion some holes may become enlarged. If any large cracks or holes
are found replace burner.
7. If grill is to be stored, coat burner lightly with cooking oil. Wrap in
protective cover to keep insects out.
8. If not storing grill after cleaning, hold briquet grate and burner together
angle into grill bottom (D).
9. To reattach clips hold large curved end away from burner tube, insert
small curved end into hole under burner tube, turn clip towards valve,
snap into place.
VERY IMPORTANT: Clips must be attached correctly for proper grill
function (B).
10. Reattach ignitor wire to ignitor (A). (Reinstall battery and ignitor button on
electronic ignition models.)
11. Do not use more than 16 new briquets on briquet grate around burner. Do
not let briquets cover burner holes.
12. Reposition drip vaporiser bar and cooking grate(s). Reattach clean can to
grease clip.
13. Before cooking again on grill, follow "Burner Flame Check".