Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
The Main oven has panels which have been coated
with a special enamel that partly cleans itself. This
does not stop all marks on the lining, but helps to
reduce the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the panels and
wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced
and the oven heated at 200°C for about one
hour. This will ensure the Cook & Clean panels are
working effectively.
Don’t use steel wool (Brillo) or any other materials
that will scratch the surface. Don’t use oven
cleaning pads.
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves first.
The side panels of either oven can be removed.
Each side of the oven
is fixed with four fixing
screws. You don’t have
to remove the screws
to remove the oven
linings. Lift each side
panel upwards and
they will slide off the
screws. Then pull them
forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
To clean the oven sides
slide out the shelves,
unhook the supports
from the oven sides
and lift out.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may be required
to move it. There are two levelling rollers at the
back and also two screw down levelling feet at
the front.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of the
fascia panel as you move the oven.
Lift the front of the cooker slightly and pull forward.
Do not move the oven by pulling the door
handles or knobs.
Move the oven a bit at a time, checking behind it to
make sure the electricity supply cable is not caught.
Make sure the cable has sufficient slack to move the
cooker forward as you go along.
If a stability chain is fitted, release it as you ease
the cooker out. Don’t forget to refit it when you
replace the cooker.
When you replace the cooker, again check behind
to make sure that the electricity cable is not caught
or trapped.