Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7.
Immediately press the left Electric Ignitor for
3-4 seconds to light the Burner.
_'\, PRESS LEFTELECTRIC
IGNITOR
.
g.
10.
If the Burner does not light, turn the Control Knob
to OFF, wait 5 minutes for gas to clear, then
retry.
Once the grill burner is ignited, the adjacent
Burner can be lit by simply turning its Control
Knob to HIGH.
Adjust Control Knobs to your desired cooking
temperature.
Side Burner Lighting Instructions
1. Follow steps 1 through 5 of the Basic Lighting
Procedures.
2.
Push and turn the Control Knob (on the right Side
Burner Frame ) for Side Burner to HIGH.
4.
5.
.
Open the Grill Lid. Failure to do so can result in
fire or explosion. See WARNING below.
Z WARNING
Failure to open Grill Lid during the
lighting procedures could result in a fire
or explosion that could cause serious
bodily injury, death, or property damage.
Set ALL Control Knobs to OFF and open the LP
Gas Tank Valve slowly until 1/4 to 1/2 open.
Open LP
Gas Tank
OFF
Push and turn the Right Control Knob for Back
Burner to HIGH.
T
HI T
OFF_ IGNIToRRIGHTELECTRIC OFF H_
(for SIDE BURNER) RIGHT ELECTRIC
IGNITOR
\\\ (for BACK BURNER)
\
\ \
\\ \
©© o
.
4.
5.
Immediately press the Right Electric Ignitor for 3-4
seconds to light the Burner.
If the Burner does not light, turn the Control Knob
to OFF, wait 5 minutes for gas to clear, then retry.
Adjust Control Knobs to your desired cooking
temperature.
Back Burner Lighting Instructions
Note: The location of the Back Burner makes it more
susceptible to winds that will decrease the perfor-
mance of your rotisserie cooking. For this reason you
should not operate the Back Burner during windy
weather conditions.
1.
2.
3.
If you have a LP Gas grill be sure the LP Gas Tank
is filled, or if you have a NG grill be sure that the
locking shut off valve is open.
Check that the end of each Burner Tube is
properly located over each Valve Orifice.
Be sure all gas connections are securely tightened.
7.
.
9.
10.
/
BACK BURNER
Immediately press the Right Electric Ignitor
for 3-4 seconds to light the Back Burner.
"_\ PRESS RIGHTELECTRIC
IGNITOR
If the Burner does not light, turn the Control Knob
to OFF, wait 5 minutes for gas to clear, then retry.
Once lit, the Back Burner will reach cooking
temperature quickly. The orange/red glow will
even out in about 5 minutes.
For best results, always rotisserie cook with the
grill lid down and the Back Burner Control Knob set
to ON. Do not use the Main Burners when the
Back Burner is in operation.
25