Kenmore 141.153373 Gas Grill User Manual


 
[] Fuel Gauge Display Installation.
Open the front Doors of Cabinet. Pull out the LPG
Tank Pull-Out Tray. Connect the Wire Plug "A" from
Fuel Gauge Display with the Wire Plug "B" from rear
of Tank Pull-Out Tray. Unscrew 1/4" x 1/2" Pattern
Head Screw(Lower) from Cart Rear Panel and fix Wire
Plug "A" into Wire Fastener. Install Wire Fastener to
Cart Rear Panel. Tighten securely using the same
screw. See Figure 12a.
Battery Replacement:
1. Stretch your hand behind Control Panel and
unscrew the Battery Cover behind the Display Box.
2. Pull out the Battery with electric wire from the Battery
Compartment.
3. Replace the used Battery with the new one.
4. Replace the new Battery with electric wire back into
Battery Compartment. See Figure 12b.
5. Screw the Battery Cover back to the Display Box.
Fuel Gauge Display Operating - See Figure 12c
Press the "CHECK" button to operate Fuel Gauge Dis-
play with the Gas Tank mounted in the Tank Pull-Out Tray.
NOTE: Tank must be positioned in tray for Fuel
Gauge Display check
1. Fuel Display: Indicates Gas Tank fill level.
2. FuelWarning Display: WhentheGasTankfitl level
is on the last row, a warning signal will sound for
approximately 3 seconds to warn you that the tank
volume is near empty.
3. Battery Warning Display: A low battery warning
light will illuminate when the battery voltage drops to
a low level. Replace the battery.
NOTES:
1. The Fuel Gauge Display lasts for approximately 20
seconds each time you press the "CHECK _'button.
After 20 seconds, the Fuel Gauge Display turns off
automatically. If you press the button a second time
within 20 seconds, the Fuel Gauge Display will be
turned off manually. If you press the button a sec-
ond time after 20 seconds, the Fuel Gauge Display
will work and last for another 20 seconds.
2. The Fuel Gauge Display works only with a tank on
the Tank Pull-Out Tray. No readout will appear if a
tank is not mounted on the Tank Pull-Out Tray.
Figure 12a
RIGHT CART LEG
CART REAR PANEL\
\\\\
WiRE FASTENER
WiRE PLUG "A"
SIDE BURNER FRAME
FUEL GAUGE DISPLAY
TANK PULL-OUT TRAY
Figure 12b
WIRE PLUG "B"
WIRE PLUG "A"
DISPLAY BOX
FUEL GAUGE
DISPLAY COVER
WiRE PLUG "A"j
9V BATTERY
.f
J
BATTERY CONNECTOR
IMPORTANT: When the Gas Tank is removed from
the Tank Pull-Out Tray, the fuel gauge display will
not operate,
Figure 12c
J FUEL INDICATOR _\
_CHECK
BUTTON
BATTERY
FUEL
WARNING
WARNING
D_SPLAY
DISPLAY
21