Kenmore 141.153373 Gas Grill User Manual


  Open as PDF
of 43
 
[] Connecting A Liquid Propane Gas (LPGas)
--Tank To Your Grill
1. Open the Doors of cabinet. Pull out the LPG
Tank Pull-Out Tray. Place a 20 Ib tank with
foot ring into the hole in the tray. See Figure
13a. Make sure the tank valve is in the OFF
positon.
2. Align the tank so the Tank Valve faces the
rear right corner of cabinet. Use the
5/16"x3-1/2" Wing Bolt to secure gas tank
from rear of tray. See Figure 13a.
3. Check the Tank Valve to ensure it has proper
external mating threads to fit the Hose &
Regulator assembly provided (Type 1 connec-
tion per ANSI Z21.58b-2002). See Figure 13b.
4. Inspect the valve connection port of the Regulator
assembly. Look for damage or debris. Remove any
debris. Inspect Hosefordamage. Never usedamaged
or plugged equipment.
5. Make sure all Burner Knobs are in the OFF
position.
6. Connect the Hose and Regulator assembly to the
Tank valve (See Figure 13b). Hand tighten Quick
Coupling Nut clockwise to a full stop. DO NOT use a
wrench to tighten because it could damage the Quick
Coupling Nut and result in a hazardous condition.
7. Open the Tank Valve fully (counterclockwise). Use a
soapy water solution to check all connections for
leaks before attempting to tight your grill. See "Check-
ing for LP Gas Leaks" on page 23. If a leak is found,
turn the Tank Valve off and do not useyour grill until the
leak is repaired.
Figure 13a (LP Gas model only)
GRILL HEAD
DOOR
'\
J _f"
GASTANK
/
TANK PULL-OUT TRAY
Figure 13b (LP Gas model only)
GRILL HEAD
Disconnecting A Liquid Propane Gas (LP Gas)
Tank From Your Grill
1. Turn the Burner Knobs and LP Gas Tank
Valve to the full OFF position. (Turn clockwise
to close.)
2. Detach the Hose and Regulator assembly from
the LP Gas Tank Valve by turning the Quick
Coupling Nut counterclockwise. See Figure 13b.
CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.
DOOR
\
\
\
TANK PULL-OUT TRAY//
\
/f QUICK COUPLING NUT \
Type 1 \
connection ALREADY CONNECTED
per ANSI TO ADAPTOR UNDER
Z21.58b-2002 SiDE BURNER.
22
 previous next