Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
6. For Natural Gas grills:
Connect the Electric Wire terminal from Side Burner
with the other from Grill Head. See Figure 8d. Bind
the connected Electric Wires, and Connection Tube
together using the supplied Fastening Band.
7. The gap between the Side Burner Electrode Tip and
the Side Burner Port should be approximately
1/8"~3/16". See Figure 8e. If the gap is wider than
3/16", use a pair of long nose pliers and gently
bend the Electrode Tip toward the Burner.
8. Slide the 5 Tool Hooks onto the Tool Holder with
hooks facing the grill Head. Attach Tool Holder
to left side of Side Shelf and secure firmly using
2 of the M5x8mm Pattern Head Screws and
washers supplied. See Figure 8f.
• When you have finished assembling your
grill we strongly urge that all Pattern
Head Thumb Screws be tightened, either
with the supplied Tightening Tool or a
#2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
Figure 8d (Natural Gas model only)
SIDE BURNER POT SUPPORT
\\\\\
_StDB BURNER
CONTROL
KNOB_
FASTENING
BAND
COTTER PIN
\
SiDE BURNER FRAME
_StDE BURNER GAS
VALVE ASSEMBLY
_ ELECTRIC WIRE
FROM SiDE BURNER
\
\
\
ELECTRIC WIRE
FROM GRILL HEAD
Figure 8e
1/8"-3/16" BURNER
PORT
9. For Natural Gas grills:
Connect the hose end of the 12' Natural Gas
Hose to the vertical fitting as shown in Figure
8g. Also read the natural gas safety instruc-
tions. (on page 4)
Figure 8g (Natural gas model only)
FOOT \SIDE BURNER
BRASSADAPTOR, f SIDE BURNER GAS VALVE
12' NATURAL GAS HOSE
Figure 8f
TOOL HOLDER
TOOL HOOK
CONNECTION TUBE
FROM GRILL HEAD M5x8rnm PATTERN
HEAD SCREW
SiDE SHELF
18