Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
110112-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
17
17
INSTALLATION
Installing Logs (Cont.)
Installing Battery Into Remote
INSTALLATION
Continued
INSTALLING BATTERY INTO REMOTE
1. Locate slot at bottom of remote control (see Figure 35). Firmly
insert tool such as a small screwdriver, butter knife, or dime
into the slot and lift up to remove cover.
2. Insert supplied battery into remote control. Positive and nega-
tive are marked inside remote control casing.
Note:
Remote
will not function if battery is not installed correctly.
3. Slide tab on cover into remote housing and snap cover back
into place.
IMPORTANT:
Use only A23 12 volt battery in remote. DO NOT
use AAA battery.
Positive
Figure 35 - Installing Battery
Negative
Tab
Cover
Remote
Control
Slot
A23 12
Volt
Battery
Figure 32 - Installing Log #2 (Right) and Log #3 (Left)
Figure 33 - Installing Log #4
Figure 34 - Installing Log #5 and Log #6
Log #6
Log #5
Log #2
Log #4
Log #3
Log #1
Log #2
Log #3
Log #1
Log #4
Log #2
Log #3
Log #1
2. Place log #2 to right of log #1 and onto log alignment screw
as shown in Figure 32. Log #2 will wrap around right end of
rear burner.
3. Place log #3 on left side of base and onto alignment screw to
right of rear burner (see Figure 32). Log #3 will wrap around
left end of rear burner.
4. Place log #4 onto two alignment screws to rear of base (see
Figure 33).
5. Locate hole on bottom of log #5 and place over pin on log #2.
Log #5 will rest on back of log #1 (ember bed). See Figure 34.
6. Place log #6 onto two pins on log #1 (ember bed) and rest
back of log #6 on back log #4 (see Figure 34).