Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
110112-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
16
INSTALLATION
Assembling And Attaching Optional Brass Trim
Installing Hood
Installing Logs
INSTALLATION
Continued
ASSEMBLING AND ATTACHING OPTIONAL
BRASS TRIM
(Included with Mantel Accessory)
Note:
The instructions below show assembling and attaching brass
trim to fireplace.
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates with set screws,
and two shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 28.
4. Slide one end of adjusting plate/shim in slot on mitered edge
of top brass trim (see Figure 28).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side brass trim (see Figure 28).
6. While firmly holding edges of brass trim together, tighten both
set screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25 shoulder) into holes
in cabinets. Place the assembled trim onto fireplace cabinet.
Align hanging notches on trim with hanging screws on side of
fireplace (see Figure 29). Push trim firmly into place, sliding
hanging notches over hanging screws.
Figure 29 - Attaching Brass Trim to Fireplace
Trim
Hanging
Screws
Assembled
Brass Trim
Hanging
Notches
on Trim
Figure 28 - Assembling Brass Trim
Slot
Mitered Edge
Slot
Shim
Set Screws
Adjusting
Plate
Side Brass
Trim
Figure 30 - Installing Hood to Firebox
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 30. Use 3 Phillips
screws provided.
Top Brass
Trim
INSTALLING LOGS
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no yellow flame comes in
contact with any log. With the heater set to HI, check to
see if flames contact any log. If so, reposition logs
according to the log installation instructions in this
manual. Yellow flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater. Before installing
logs, make sure log alignment screws are in place and straight.
1. Place log #1 (ember bed) onto base over log alignment screws
to the left of front burner and behind middle burner. Log #1
will sit on top of front and middle burners (see Figure 31).
Figure 31 - Installing Log #1 (Ember Bed)