Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
111410-01C
For more information, visit www.desatech.com
For more information, visit www.desatech.com
10
Note:
If you are using a mantel with your heater, use the following
instructions. If your heater is built-in, see For Built-In Installation
on page 12.
1. Screen and hood should be removed from fireplace (see page
10). Remove log set and set aside.
2. Install snap bushings found in hardware kit into both holes in
rear of blower control shield (see Figure 15).
3. Make sure the wire harness is firmly connected to the terminals
on the blower bracket assembly.
Snap Bushing
Figure 15 - Installing Snap Bushings
Blower Control
Shield
CAUTION: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause im-
proper and dangerous operation.
CAUTION: Verify proper operation after servicing.
Figure 14 - Attaching Trim to Fireplace
A
U
T
O
O
F
F
O
N
Shoulder Screws
Assembled Trim
INSTALLING BLOWER ASSEMBLY - GA3450T
INSTALLATION
Continued
Figure 12 - Removing Hood Screws
Hood
Screen Rod
Cover
Hex Head
Screw
Figure 13 - Removing Hood
Mantel Screw
Location
Figure 11 - Removing Screen
7. Carefully place fireplace on mantel base and center left to
right. Check for gas leaks. See Checking Gas Connections,
pages 14 and 15.
8. Refer to instructions provided with the mantel for permanent at-
tachment to wall.
9. Slide mantel around fireplace. Be careful not to damage wall
or mantel.
10. Adjust assembly to remove any gaps. From back side of fire-
place, attach two 2" wood screws through base mounting blocks
attached to bottom sides of mantel into base (see instructions
provided with mantel).
11. Attach remaining two 3" wood screws from hardware pack
through openings inside of fireplace sides into the mantel. See
Figure 13 for screw hole location.
Screws
Screws
INSTALLATION
Optional Mantel Installation (Cont.)
Installing Blower Assembly - GA4350T