Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 10 R-3848
Stainless Steel
The Superb gas grill is made from stainless steel. There are many different
stainless steel cleaners available. Always use the mildest cleaning meth-
ods first, scrubbing in the directions of the grain. To touch up noticeable
scratches in the stainless steel, sand lightly with dry 100 grit emery paper
or scotch bright pad in the direction of the grain. Specks of grease can
gather on the surfaces of the stainless steel and bake on to the surface
giving the appearance of rust. To remove this grease buildup scrub with
a strong degreaser in the direction of the grain. Coat with lemon oil or a
stainless steel shine product to protect its finish after cleaning.
Cleaning Grill Plates
The grill plates should be cleaned regularly because of grease build-up
and other debris. Keeping the grill plates clean will greatly reduce flare
ups and grease fires.
The easiest way to clean the grill is immediately after cooking is
completed. Be sure the burners are turned off and there are no flames
before beginning. Wear a barbecue mitt to protect your hand from the heat
and steam. Using a brass bristle barbecue brush, scrub the hot grill plates.
If the grill is allowed to cool before cleaning, the cleaning process will be
more difficult.
NOTE: DO NOT USE CAUSTIC CLEANERS such as oven
cleaners, etc. This will damage the grid surface and void your
warranty.
Side Burner Grate
The side grate is stainless steel. Do not attempt to clean a hot grate. When
the grate cools it may be wiped with hot soapy water, then rinsed and
wiped dry. Never immerse a hot grate in water as the hot steam produced
could cause burns.
Drip Trays
The drip trays will collect grease from the grill area. Do not attempt to
remove or clean until thoroughly cooled. To avoid grease fires or flare-
ups be sure to clean out the grease often.
Grill Burners
The grill burners are constructed of cast stainless steel and should only
require minimal maintenance. However, they should be checked periodi-
cally and cleaned if needed.
Figure 10
Side Burner
The side burner is constructed of cast stainless steel. Occasional cleaning
of the burner ports will be necessary.
Flashback from Spiders (Figure 10)
In some areas of the country, spiders or small insects have been found to
create "flashbacks" problems. The spiders spin webs and/or insects build
nests in the burner venturi tube(s). The web and/or nests can lead to gas
flow obstruction which results in a "flashback" (a fire in the venturi
tube(s). Clean interior of burners with a flexible, soft bristle, bottle brush
in order to remove spiders, spider webs and debris.
CLEANING PRODECURES
Removing Main Burners (Figure 11)
1. Turn OFF gas supply to grill.
2. All grill parts must be cool before attempting to clean.
3. Remove the chip tray.
4. Remove (4) grill plates.
5. Remove ceramic plaques and plaque rack.
6. Remove (5) burner hoods located above main burners.
7. Remove right end and left end of inner liner by removing (2) screws
from each end.
8. Remove inner liner by removing (6) screws.
9. Remove (1) bolt from each main burner.
10. Lift rear section of main burner in order to remove main burner from
orifice fitting.
11. Clean interior of main burner with a flexible, soft bristle, bottle brush
in order to remove spiders, spider webs and debris. Apply air
pressure to burner ports to remove debris.
12. Be careful not to change the air shutter's original position. Once
reinstalled, light all of the burners and check for proper flame.
13. To replace main burners, reverse above procedure starting with Step
10.
Removing Side Burner (Figure 11)
1. Turn OFF gas supply to grill.
2. All grill parts must be cool before attempting to clean.
3. Remove side burner lid.
4. Remove side burner grate.
5. Remove (2) screws from side burner.
6. Lift rear section of side burner in order to remove side burner from
orifice fitting.
7. Clean interior of side burner with a flexible, soft bristle, bottle brush
in order to remove spiders, spider webs and debris. Apply air
pressure to burner ports to remove debris.
8. To replace side burner, reverse above procedure starting with Step
6.
Additional Steps to Clean Main Burners and Side Burner
1. Turn OFF gas supply to grill.
2. All grill parts must be cool before attempting to clean.
3. Clean the exterior of the burner with a wire brush.
4. Clear any clogged ports with a straightened paper-clip.
5. Never use a wooden toothpick as it may break off and clog the port.
6. Shake out any debris through the air shutter.
7. Use a flashlight to inspect the burner inlet to ensure it is not blocked.
8. If an obstruction can be seen, use a straightened metal wire coat-
hanger to clean it out.
CARE AND MAINTENANCE