Weber PL - PG. 59 57205 Gas Grill User Manual


  Open as PDF
of 84
 
WWW.WEBER.COM
®
19
MAIN BURNER IGNITION & USAGE
MAIN BURNER IGNITION
Lighting with a Match
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting
the grill’s burners, or not waiting ve
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive are-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off(2). Check by pushing control knobs in and turning
them clockwise until they stop.
m WARNING: The burner control knobs
must be in the off ( ) position before
you turn on the LP cylinder valve. If
they are not in the off ( ) position
when you turn on the LP cylinder
valve, the “excess gas ow control”
feature will activate, limiting the ow of
gas from the LP cylinder. If this should
occur, turn off the LP cylinder valve
and burner control knobs. Start over.
m DANGER
When the “excess gas ow control”
feature is activated, a small amount of gas
is still owing to the burners. After turning
off the LP cylinder valve and burner
control knobs, wait at least ve minutes
for the gas to clear before attempting to
light the grill. Failure to do so may result
in an explosive are-up, which can cause
serious bodily injury or death.
C) Turn the LP cylinder on by SLOWLY turning the
cylinder valve counterclockwise (3).
D) Put match in the matchstick holder and strike match.
Insert matchstick holder with lit match down through
the cooking grates, past the Flavorizer
®
bars and next
to burner1 (4).
E) Push burner 1 control knob in and turn it
counterclockwise to start/high ( ) position (5).
IMPORTANT: Always ignite burner 1 rst. The other
burner(s) ignite from burner 1.
F) Check that burner 1 is lit by looking through the
cooking grates. You should see a ame.
m WARNING: Do not lean over the open
grill.
m WARNING: If burner 1 fails to ignite
within ve seconds, stop, turn the
burner control knob to off and wait
ve minutes to allow the gas to clear
before you try again.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3).
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
1
2
4
3
5
 previous next