Weber 300 Gas Grill User Manual


  Open as PDF
of 72
 
36
ANNUAL MAINTENANCE
Inspection And Cleaning Of The Spider/Insect Screen
If there is dust or dirt on the Spider/Insect screen, remove the burner to clean the
screen. Refer to “BURNER TUBE CLEANING OR REPLACEMENT”.
Brush the Spider/Insect screen, lightly, with a soft bristle brush (i.e. an old toothbrush).
m CAUTION: Do not clean the Spider/Insect screen with hard
or sharp tools. Do not dislodge the Spider/Insect screen or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/
Insect screen and burner is clean, replace the burner.
If the Spider/Insect screen becomes damaged or cannot be cleaned, contact the
Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
Main Burner Flame Pattern
The Weber
®
gas barbecue burner has been factory set for the correct air and gas
mixture. The correct flame pattern is shown.
A) Burner tube (1)
B) Tips occasionally flicker yellow (2)
C) Light blue (3)
D) Dark blue (4)
If the flames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures.
◆
3
1
2
4
mAINTeNANce
m ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country
designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products LLC, Customer Service
Department for genuine Weber-Stephen Products LLC replacement part(s) information.
m WARNING: Do not attempt to make any repair to gas carrying, gas burning, igniter components or structural components
without contacting Weber-Stephen Products LLC, Customer Service Department. Your actions, if you fail to follow this
Product Warning, may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as
damage to property.
 previous next