Weber 300 Gas Grill User Manual


 
24
GAS INSTRUcTIoNS
LIQUID PROPANE CYLINDER CONNECTION
m WARNING: Make sure that the LP cylinder valve is closed.
Close by turning valve clockwise.
m DANGER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for leaks. Sparks or flames will result in a fire or
explosion which can cause serious bodily injury or death,
and damage to property.
HOSE TO CYLINDER CONNECTION
m WARNING: The hose must be secured to the cart leg by the
hose retention clip. Failure to do so could cause damage
to hose resulting in a fire or explosion, which can cause
serious bodily injury or death and damage to property.
A) Remove the plastic dust cover from the tank valve.
B) Screw the hose coupling onto the tank valve, clockwise, or to the right. Hand-tighten
only.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to
flow unless the connection is tight. The connection requires tightening by hand only.
m WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
CHECK FOR GAS LEAKS
Check That The Burner Valves Are Off
Check by pushing the control knob in and turning clockwise. Confirm that the knob is set
in the “OFF” indicator position. Proceed to the next step. If the control knob does turn,
continue turning clockwise until it stops. It is now in the OFF position. Proceed to the
next step.
m WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
m WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled.
m WARNING: Do not ignite burners when leak checking.