Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
22
106516
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
®
BHDV34NB AND BHDV34PB
REMOVING/REPLACING
GLASS DOOR
CAUTION: Do not operate this
fireplace with a broken glass door
panel or without the glass door
panel securely in place. For re-
placement part information see
Replacement Parts
, page 32.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 46).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 47).
4. To replace glass door, follow the above
instructions in reverse.
Figure 47 - Removing/Replacing Glass
Door
Figure 46 - Removing Top Louver Panel
Top Louver
Panel
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
FIREPLACE
INSTALLATION
Continued
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt alka-
line battery (not included). Place bat-
tery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 45 - Installing Alkaline Battery in
Hand-Held Remote Control Unit
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Installing 9-Volt Alkaline Battery
into Receiver
1. Open bottom louver and locate the
switch bracket on the left.
2. Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3. Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt al-
kaline battery (not included) through
the clip.
4. Attach the terminal wires to the battery.
5. Remove the wire that runs from TH to
TPTH from the valve (see Figure 40,
page 21).
6. Connect wires from receiver to TH and
TPTH on the valve (see Figure 41,
page 21).
7. Replace the switch bracket.
Figure 44 - Attaching Alkaline Battery to
Receiver
9-Volt Battery
Receiver
Terminal
Wires
Battery Clip
Glass Door
Assembly
Screw
Lower Bracket for
Glass Door Assembly
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
ACCESSORIES - GHRC AND
GHRCT
NOTICE: Use only alkaline bat-
teries (not included).