Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
110150-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
14
WARNING: You must operate this fireplace insert
with the fireplace insert screen in place. Make sure
fireplace insert screen is in place before running
fireplace insert.
Figure 25 - Installing One Piece Log Set (Top View)
Figure 26 - Installing Fireplace Insert Screen
Notches
Screws for
Mounting
Screen
One Piece Log Set
Burner
Ports
2. Install fireplace insert screen by slipping notches of fireplace
insert screen over screws on front of fireplace insert (see Fig-
ure 26).
INSTALLATION
Continued
INSTALLATION
Installing Logs (Cont.)
Optional Wireless Hand-Held Remote Control Accessories
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES (GHRC and
GHRCTA)
Installing Remote Receiver Unit
1. Disconnect switch wires from the control valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 27). Discard after removing.
4. Install remote receiver unit onto gas log heater base using
mounting clips.
5. Push clips firmly into place (see Figure 28).
6. Connect wires as shown in Figure 29.
Figure 27 - Switch Plate and Wiring Harness
Screw
Switch Plate
Wires
Figure 28 - Installing Remote Receiver
Remote Receiver
Mounting
Clips
Remote
Switch
Bracket
Ignitor
Figure 29 - Connecting Wires
Red Wire
From
Receiver
Valve
White Wire
From Receiver