Taylor 811 Gas Grill User Manual


 
3
Model 811, 813, 819, 821 Series To the Operator
120525
Section 2 To the Operator
The Taylor grills included in this manual consist of
the base model numbers 811, 813, 819, and 821.
Prefix letters were added to the base model
numbers to denote minor design differences:
C = Standard Platen Length (17.5” / 445 mm)
L = Longer Platen Length (21” / 533 mm)
G = Grooved Option
The models 811 and 813 are 36” (914 mm) grills.
The 811 is equipped with three upper platens and
the 813 is equipped with two upper platens.
The models 819 and 821 are 24” (610 mm) grills.
The 819 is equipped with two upper platens and the
model 821 is equipped with one upper platen.
These grills are capable of cooking a variety of
products and feature two cooking options. They
provide all the features of a flat grill as well as the
advantages of two-sided cooking.
The grill you have purchased has been carefully
engineered and manufactured to provide
dependable operation. When properly operated and
maintained, it will produce a consistent quality
product. Like all mechanical products, it will require
cleaning and maintenance. A minimum amount of
care and attention is necessary if the operating
procedures in this manual are followed closely.
This Operator's Manual should be read before
operating or performing any maintenance on your
equipment.
It is strongly recommended that all personnel
responsible for the equipment's operation and
cleaning review these procedures for proper training
and assurance that no misunderstandings exist.
In the event you should require technical assistance,
please contact your local authorized Taylor
Distributor.
Note: Warranty is valid only if the parts are
authorized Taylor parts, purchased from an
authorized Taylor Distributor, and the required
service work is provided by an authorized Taylor
service technician. Taylor reserves the right to deny
warranty claims on equipment or parts if
non-approved parts or refrigerant were installed in
the machine, system modifications were performed
beyond factory recommendations, or it is determined
that the failure was caused by neglect or abuse.
Note: Constant research results in steady
improvements; therefore, information in this
manual is subject to change without notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other
similar legislation in effect after August 13, 2005.
Therefore, it must be collected separately after its
use is completed, and cannot be disposed as
unsorted municipal waste.
The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or
local distributor.