Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
29
Model 811, 813, 819, 821 Series Operating Procedures
120127
Step 2
Use the wiper squeegee to clean the release sheet
on the upper platen. Hold the handle at a slight
upward angle. Use a downward motion to clean the
sheet. (Note: Do not use excessive pressure when
wiping the release sheet with the squeegee, as this
can scratch or tear the r elease sheet.)
Figure 43
Step 3
Using the wiper squeegee, push the grease at the
rear of the lower grill surface into the grease can. Do
not use the grill scraper for this step.
Step 4
Usethegrillclothtocleanthebacksplashplateand
the bullnose areas as needed during operation.
Note: To increase the life of the release sheet, wipe
it with a clean, sanitizer-soaked, folded grill cloth a
minimum of four times every hour.
CAUTION: The upper platen surface is
very HOT! To prevent burn injuries, use extreme
caution when wiping the release sheet.
Daily Cleaning Procedures
Note: The three platen Model L811 has been
selected to illustrate the step-by-step procedures.
For grills equipped with less than three platens,
perform the following steps as appropriate for your
grill platen configuration.
Step 1
Raise the upper platen to the OPEN position by
pressing the red RAISE button.
Figure 44
CAUTION: Never use force to raise the
upper platen. Damage to components may
result. Only use the RAISE button to open the
upper platen!
Note: DO NOT turn the power switch to the OFF
position while the platens are in the “down” position.