Lennox Hearth 33/40 DV INS Fire Pit User Manual


 
19
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
To Turn Off Gas To Appliance
1. Turn off the “ON/OFF” rocker switch and/or thermostat (if installed).
2. Turn off electric power to the appliance if service is to be performed.
3. Turn gas control knob clockwise to “OFF”. Do not force.
This appliance needs fresh air for safe operation and must be installed
so there are provisions for adequate combustion and ventilation air. See
Installation and Operation Manual accompanying appliance.
Operation of this appliance when not connected to a properly installed and
maintained venting system can result in carbon monoxide (CO) poisoning and
possible death.
Shutdown Procedure
1. To turn off the burner, switch the rocker switch to “OFF” or adjust the
thermostat to a setting below room temperature (if installed). The
pilot will remain lit for future burner ignition.
For complete shutdown: See “To Turn Off Gas To Appliance” above.
Lighting Instructions
STOP! Read the safety information on the front cover of the manual
before proceeding.
1. Open the right side access door. Ensure the gas supply shut-off cocks are
open and ON/OFF Rocker Switch is “OFF”. If equipped with a thermostat,
set it to the lowest setting.
2. Turn off all electrical power to the appliance.
3. Push in the gas control knob slightly and turn clockwise to “OFF”.
NOTE: The knob cannot be turned from “PILOT” to “OFF” unless the knob
is pushed in slightly. Do not force.
4. Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow
instructions on the front cover of this manual. If you do not smell gas
continue.
5. Locate the pilot assembly by looking at the rear center of the burner,
behind the large center log. A blue flame will be seen when the pilot is
lit.
6. Turn the gas control knob counterclockwise to the “PILOT” posi
-
tion.
7. Push the knob all the way in and hold in that position. Immediately light
the pilot by pressing the igniter button several times until pilot is lit.
Continue to hold the knob in for about 30 seconds after the pilot is lit.
Release knob and it will pop back out. Pilot should remain lit. If it goes
out, repeat steps 4-8 holding knob in an additional 15 seconds after pilot
is lit.
If knob does not pop out when released, stop and immediately call
your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control knob
to “OFF” and call your service technician or your gas supplier.
8. After pilot is lit, turn gas control counterclockwise to “ON”. Knob
can only be turned “ON” if the knob has popped out.
9. To turn burner on, turn “ON/OFF” rocker switch to “ON” or set the ther
-
mostat to the desired temperature above room temperature.
10. Adjust the flame height (and heat output) by turning the flame height
knob clockwise for reduced flame and counterclockwise
for full flame.
11. Set the blower to the desired air flow after it turns on when the appliance
reaches operating temperature.
Gas Control Knob
(Pilot / On / Off)
Flame Height
Control Knob
(Hi/Lo)
Piezo Igniter
CAUTION
Your Shoreline™ gas appliance must always be
operated with glass door in place.
WARNINGS
Improper installation, adjustment, alteration,
service or maintenance can cause injury or
property damage. For assistance or additional
information, consult a qualified installer, service
agency or your gas supplier.
Operation of this appliance when not connected
to a properly installed and maintained venting
system can result in carbon monoxide (CO)
poisoning and possible death.
Carbon monoxide poisoning – early signs of
carbon monoxide poisoning resemble the flu
with headaches, dizziness, or nausea. If you
have these signs, get fresh air at once! Have the
heater inspected by a qualified service techni-
cian. Some people are more affected by carbon
monoxide than others. These include pregnant
women, people with heart or lung disease or
anemia, those under the influence of alcohol,
and those at high altitudes.
Figure 31 - Gas Controls
Figure 32 - Pilot Assembly
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
Igniter (electrode)
Pilot Hood
Thermopile
Thermocouple
Pilot Assembly
ON/OFF
Switch
Blower Speed
Control (rheostat)