Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
side of Grill Head, install the Grease Draining
Traywith its drain hole to left, which is the
side opposite from the Tank Pull-Out Tray.
See Fig. 7.
From the front side of cabinet, open the front
doors and Install the Grease Receptacle under
Grease Draining Tray. See Fig. 7.
Figure 7
GRILL
HEAD
\
GREASE
DRAIN-
ING
TRAY
HEAT
SHIELD
Installing Manual Lighting Stick
Attach the Manual Lighting Stick to the Left
Bowl Support Bracket as shown in Fig. 8.
Align the hole at the end of Manual Lighting
Stick Wire with the threaded hole on the Left
Bowl Support Bracket. Tighten securely using
the M4x8mm Pattern Head Screw packed with
the Manual Liqhtinq Stick.
Figure 8
FRONT
DOOR
GREASE
RECEPTACLE
;EMBLED
VALVE KIT
Figure 9
SIDE SHELF FRAME
GRILL HEAD
PANEL-LEFT
M4x8mm PATTERN
HEAD SCREW
MANUAL LIGHTING
STICK
SIDE BURNER
FRAME
Installing Side Shelf, Side Burner and Tool
Holder Kit
Remove Side Burner from Side Burner Kit before
installing.
Enlisting the aid of an assistant, attach Side Burner
Frame to right side of grill. Attach Side Shelf
Frame to left side of grill as shown in Fig. 9.
Align the 4 holes on Side Shelf Frame and Side
Burner Frame with the threaded holes on left and
right Bowl Support Brackets. Tighten securely
using 4 of the 1/4"x3/4" Pattern Head Screws
provided.
Install the Pre-assembled Valve Kit to the Side
Burner Frame. See Fig. 9a. Attach the Pre-
assembled Valve Kit to the Side Burner Valve Hole
on the Side Burner Frame, as shown in Fig. 9a.
Align the 2 holes on the Side Burner Frame with
the threaded holes on the Side Burner Valve
Bracket. Tighten securely using 2 of M4x8mm
Pattern Head Screws and 2 Washers packed with
the Control Knob.
Cut Fastening Band from Pot Support and set
Pot support aside. Install the Side Burner through
the top hole in Side Burner Frame and onto the
Side Burner Valve. Make sure that opening at
BOWL SUPPORT
BRACKET-RIGHT
Figure 9a
M4x8mm _"_'_
PATTERN HEAD
SCREW AND
WASHER
11
HOLES FOR SIDE
BURNER VALVE KIT
BURNER
FRAME
EMBLED
VALVE KIT
BURNER
VALVE BRACKET