Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11 13
A. IntelliFire Plus™ Pilot Ignition System Wiring
• This appliance is equipped with an intermittent pilot ignition
(IPI) control which operates on a 6-volt system.
• This appliance is supplied with a battery pack which is
located in the control box. A wiring diagram is shown in
Figure 6.1.
• The battery pack requires four batteries (not included).
• An optional electric kit is available. This allows the system
to be operated with 110/120 VAC instead of batteries. See
Section 6.B.
• The appliance comes standard with an OFF/ON switch
on the control box lid
• Optional RC100 wireless wall switch (OFF/ON)
• Optional RC200 wireless remote allows fl ame adjustment
(AUX200 is not required since there is no fan used).
6
6
Electrical Information
Figure 6.1 Intermittent Pilot Ignition (IPI) Wiring Diagram
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
WARNING! Risk of Shock! Label all wires prior to discon-
nection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation
after servicing.
NOTICE: RC100 & RC200 must be protected from the
elements.
• The module should be in the REMOTE position when
using the switch preinstalled in the control box lid when
using the RC100 wireless wall switch. Putting the switch
in the OFF position will disable all fi replace controls. See
ON/OFF/REMOTE inset, Figure 6.1.
Hearth & Home Technologies recommends that IntelliFire
Plus
TM
wireless controls be used for their features and
functionality with the IntelliFire Plus
TM
ignition system.
RC100 (optional)
External
Control
Switch
Valve
Module
Pilot
assembly
Wiring
harness
Jumper
wire
Battery
holder
RED
RED
RED
BRN
BLK
BLK
GRN
ORG
ORG
WHT
Optional Electric Kit
Outlet box/Cover
Outdoor
GFI Outlet
Power
supply
RED
BLK
Battery pack MUST be removed to install
the optional electric kit.
RC200 (optional)
Wiring Assembly