Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
24
The DVC500 grate system is composed of four
pieces: the grate holder, (2)-63 hole grate inserts,
and grate angle. The grate angle is bolted to the
grate holder with (2) 3/8 x 1 1/4 bolts. Before
installing the grate holder, 3/8" round gasket must
be checked in the groove on the bottom side of the
grate holder, as shown in Fig 31. Check to be sure
the gasket has not been damaged.
The grate holder must be installed through the top
door opening after the feeder has been installed.
Locate the ange at the rear of the grate holder
into the slot on the feeder as shown below. Bolt the
front end down with the 1/4 x 20 allen bolt and nut
provided. The rear end will be locked in place by
the ange. Before tightening the bolt, be sure the
grate holder is back as far as possible and centered
side to side on the feeder opening.
Install grate inserts as shown at left. Seal joints
with high temp furnace cement caulking as shown
in Fig 30. Insert rst grate and squeeze into
caulking. Caulk other grate insert, Fig 29, on edge
that joins grate already in place. Insert caulked
grate in remaining space and squeeze together to
make middle joint as tight as possible. Clean any
caulking that has pushed out from the joints on top
of grates. Let caulking cure before ring.
Install rebricks
as shown
Fig.33
Fig. 29
Fig.30
grate insert
grate angle
grate holder
Fig.31
bottom groove
IMPORTANT
Be sure the grate holder is centered and back
as far as possible.
Fig.32
gasket