Harman Stove Company DVC-500 Outdoor Fireplace User Manual


  Open as PDF
of 36
 
21







1. Remove Ash Pan then remove ash shield behind
Ash Pan, g.22. Lift the shield up and forward
in order to remove it from the stove. This will
expose the Blower Cover and Latch, g.23.
2. Rotate the Latch counterclockwise to the vertical
position as shown in g. 24.
3. Remove the Blower Cover by tilting the left side
slightly forward. Next, slide the Cover left and
out of the slot that holds the right side in place.
The Cover can now be removed to expose the
Draft Blower Wheel and Exhaust Outlet, g. 25.
4. The blower wheel, blower housing, and exhaust
outlet can now be cleaned with a brush and
vacuum cleaner. NOTE: The ESP probe is
located at the rear of the exhaust outlet shown
in g 28. 

5. Open the Fines Cover on the bottom of the
feeder under the grates and clean, see g.26.

   


6. Check the ue pipe for excess buildup of y ash
and clean if necessary.
7. Clean the glass thoroughly, use a safety razor
to scrape the sulfur buildup from the surface
of glass. Then clean with standard window
cleaning uid, g.21.
8. Inspect all gaskets for damage and turn the
control to "test", for motor test before relighting
a re.
Fig 23Latch Blower Cover

Fig 24
Rotate Latch
Fig 22
Never Block Air Outlets on top of stove, above door.
Ash Shield
Tabs
 previous next