Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Setup
8 3A1214B
Setup
Charge Battery
If the battery is newly purchased or has not been used
for a long time, charge it before you use it.
Installing RoadLazer Into Vehicle
RoadPak Installation
(24G624, 24G625)
Load RoadPak into vehicle using a forklift or a hoist that
is rated for the weight capacity of the RoadPak. For
RoadPak weight information see Technical Data, page
27.
The RoadPak can be mounted in the front or rear of the
vehicle bed as well as in any orientation desired. The
base of the RoadPak is 39.5 in. x 49.5 in. (1.0m x
1.25m).
After mounting the RoadPak on the vehicle, firmly
secure the RoadPak to the vehicle using the tie-down
brackets at all four corners, or by bolting the RoadPak
through the bed of the truck to the frame in all four loca-
tions.
RoadLazer needs to be properly secured to prevent it
from moving during transportation and operation.
Paint drums are heavy and could shift from side to side
when the vehicle is cornering. The paint drums could
fall from the vehicle and cause injury or death. Secure
the drums when the vehicle is in transport or spraying.
Paint could splash from the paint drum bung adapters
when the paint drums are full and the vehicle is mov-
ing. Do not overfill the paint drums.
ti16442a
ti16665a
ti16653a
ti16654a
ti16664a
ti16599a
ti16443a