Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Operation
3A1214B 23
6. When paint comes out of return lines, set hydraulic
valve to OFF position.
7. Close all dump valves.
8. Place return lines into paint drum.
Prime Guns
1. Close air valve to pressurize air system.
2. Open only spray gun ball valves corresponding to
paint pumps or color used. NOTE: Never open both
ball valves on the two-color gun at the same time.
Paint color contamination could result.
3. Turn guns on with Programmable Skipline Controller
(see Skipline Controller manual).
4. Place an empty pail under spray guns to catch
drainage from spray guns.
5. Set hydraulic valve(s) to ON position to activate
pumps.
6. Turn off guns with Programmable Skipline Control-
ler.
Turn on Bead System
1. Turn bead system valve to ON position.
2. Set desired bead tank pressure by turning regulator
knob.
3. Remove and secure ground strap from earth
ground.
4. System is now ready for painting. Select guns 1 or 2
with the Programmable Skipline Controller.
Begin to Spray
Select appropriate procedure from menu on RoadLazer
control system. See Skipline Controller manual.
ti16551a
ti16959a
ti15657a
ti16920a
ti16549a
+
ti16910a