Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
USER INSTRUCTIONS
4
1. GENERAL
1.1 Installation and servicing must only be carried out by a
competent person.
1.2 In all correspondence, please quote the appliance type and
serial number, which can be found on the data badge
adjacent to the control knob.
1.3 Ensure that curtains are not positioned above the fire, and
that there is a 300mm minimum clearance between the sides
of the fire and any curtains.
1.4 This product is guaranteed for 12 months from the date of
installation, as set out in the terms and conditions of sale
between Gazco and your local Gazco dealer. Please consult
with your local Gazco dealer if you have any questions. In all
correspondence always quote the Model Number and
Serial Number.
1.5 Parts of this appliance become hot during normal use. It is
therefore recommended that a suitable fire guard be used for
protection of young children and the infirm.
2. LIGHTING THE FIRE
2.1 Locate the control valve on the appliance. There are two
control knobs on the valve, the right hand knob controls the
pilot ignition and the left hand knob controls the main burner.
2.2 If your appliance has already been upgraded to battery
remote control, please refer to the instructions provided with
the upgrade to operate the remote control. The following
instructions will work for either situation.
1
AR0914
2.3 Ensure that the left-hand control knob is pointing to off .
2.4 Ensure that the right hand control knob is pointing to off .
2.5 Press in the right hand control knob and rotate it anti-clockwise
until a click is heard (keep pressing in) and the knob is pointing
to pilot ( ). The pilot should now light. If the pilot has not
lit,
repeat the procedure until it does.
2.6 Keep the control knob pressed for 10 seconds and then
release it, the pilot should stay alight. If the pilot goes out,
repeat the procedures until it does.
2.7 If the pilot will not light after repeated attempts, contact the
retailer or installer from whom the appliance was purchased.
2.8 Turn the right hand control to point to main burner ( ). The
appliance can now be controlled using the left hand control
knob.
2.9 Turn the left hand control knob to point to low fire ( ), the
main burner will light on low. The burner can now be
controlled between low and high settings. Turn the control
knob anti clockwise increase the flame height and clockwise
to decrease the flame height.
THE YELLOW FLAMES WILL APPEAR WHEN THE FIRE HAS
GAINED SUFFICIENT HEAT - TYPICALLY 10 TO 20 MINUTES.
3. TURNING THE FIRE OFF
3.1 To turn the fire off, locate the control valve, turn the left-
hand control knob until it points to off ( ). The main burner
will go out leaving the pilot burning.
3.2 To turn the pilot off, locate the control valve, turn the right
hand control knob until it points to off ( ), the pilot will
go out.
4. LIGHTING THE FIRE WITH A MATCH
If the pilot does not ignite as described in Section 2,
please consult your GAZCO dealer to rectify the problem.
However, the appliance may be lit as a temporary measure
using the following procedure:
4.1 Press in the right hand control knob and rotate it anti-
clockwise until a click is heard (keep pressing in) and the
knob is pointing to pilot ( ), apply a lighted match to the
pilot hood, see diagram 2.
2
AR1164
4.2 When the pilot is alight, extinguish the match and continue
to depress for 5 to 10 seconds.
4.3 The fire may now be controlled as previously described.
5. UPGRADING YOUR FIRE
5.1 Your fire is fitted with a control valve that can easily be
upgraded to battery powered remote control. This upgrade