Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12
INSTALLATION INSTRUCTIONS
INSTALLATION
4.1 Before installation, ensure that the local distribution
conditions (identification of the type of gas and pressure)
and the adjustment of the appliance are compatible. See
table above.
4.2 Ensure that the gas supply is capable of delivering the
required amount of gas, and is in accordance with the rules
in force. Please refer to the technical specification for the
correct working pressure for the gas used.
4.3 Soft copper tubing and soft soldered joints can be used but
must not be closer than 50mm (2”) to the underside of the
burner.
4.4 An isolation device is provided with the appliance.
4.5 All supply gas pipes must be purged of any debris that may
have entered, prior to connection to the appliance.
5. PREPARING THE APPLIANCE
5.1 Remove the 6 burner retaining screws and withdraw the
burner unit from its location. See diagram 1, arrows B
1
AR1175
5.2 Decide on the retention method. If cable fixings are to be
used, remove the two knockout holes on the rear of the
box, using a sharp hammer blow. See diagram 2.
2
AR1154
5.3 Remove the backing from the self-adhesive silicone sealing
strip and apply to the rear flange of the firebox ensuring that
it is positioned as close to the outer edge as is practically
possible. See diagram 3.
1. UNPACKING
1.1 Remove the appliance from its packaging, and check that it
is complete and undamaged.
1.2 Put the loose ceramic parts to one side so that they are not
damaged during installation.
2. CONTROL UPGRADE
2.1 Your fire is fitted with a control valve that can be easily
upgraded to battery powered remote control. This upgrade
can be fitted by anyone capable of simple DIY jobs and
requires no special training. This upgrade can be obtained
through your local Gazco stockist.
2.2 STANDARD REMOTE CONTROL This remote control can
control the fire after the pilot has been lit. It can turn the
main burner on and regulate it from low through to high and
back again. It can turn the main burner off leaving the pilot
burning. GAZCO PART NUMBER 8455.
3. SAFETY PRECAUTIONS
3.1 This appliance must be installed in accordance with the rules
in force, and used only in a sufficiently ventilated space.
Please read all instructions before installation and use of this
appliance.
3.2 These instructions must be left intact with the user.
3.3 Do not attempt to burn rubbish on this appliance.
3.4 In your own interest, and those of safety, this appliance must
be installed by a competent person in accordance with local
and national codes of practice. Failure to install the appliance
correctly could lead to prosecution.
3.5 Keep all plastic bags away from young children.
4. INSTALLATION OF THE GAS SUPPLY
NATURAL GAS @ 20mbar BUTANE @ 29mbar
PROPANE @ 37mbar
8306MCUC 8306PCUC P8306MCUC P8308MCUC
8308MCUC 8308PBUC P8308MCUC P8308PBUC
TO CHANGE FROM ONE GAS TYPE TO ANOTHER A
COMPLETE ENGINE ASSEMBLY WILL BE REQUIRED.
SEE SECTION 8 SERVICING INSTRUCTIONS.