Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Part # 4526884 Rev 4 (10/08/10)Page 20
• Rinse the edges of all
three platens.
• Press green button to raise
center platen.
• Pour a small amount of
lukewarm water on a
clean, sanitizer-soaked
grill cloth over the bottom
grill surface and wipe o
residue.
• Place upper platen release
material sheets at on the
lower grill surface.
• Gently clean both sides of
the release material sheets
with the grill cleaning pad.
• Rinse both sides of the
release material sheets
with a clean, sanitizer-
soaked grill cloth.
• Reinstall the release
material sheets. Secure in
place with bars and clips.
• Wipe lower grill with a
clean,sanitizer-soaked
grill cloth. Repeat until no
visible soil remains.
• Empty, wash, rinse,
and replace the grease
troughs.
• Wipe remaining grill
surfaces with a clean,
sanitizer-soaked grill cloth.
• Apply a thin coat of fresh
shortening to the lower
grill surface only.
CLEANING AND MAINTENANCE continued
PLATEN ZEROING
Turn Master power switch “ON”, wait for controllers to display
“OFF”.
Note: Release sheets should not be installed during this
procedure.
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9
enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press
two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5. Press
six, (6) times. “PLATEN SET +/- XX” is displayed.
(XX=numbers that will vary from grill to grill.)
6. Allow time for grill to heat and turn ready. Press
both the Cancel (Green) and Standby (Black) buttons
simultaneously to lower the upper platen. Press the