Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Part # 4526884 Rev 4 (10/08/10)Page 18
CLEANING AND MAINTENANCE
Cleaning During Operation:
1. After each product load is removed, Use a grill scraper to
scrape grease on lower grill plate from front to back only.
Do not scrape left to right across the lower grill plate with
the grill scraper.
2. Use a grill squeegee to clean release material sheet on
upper platen in a downward motion. Do not press hard
against the release material sheet to prevent scratching
or tearing.
3. Push the grease to the rear of the grill, or pull it to the
3. Press the ENTER key
to initiate the clean mode.
4. The display SHOWS the message “READY TO CLEAN” with
ashing in the second line when the actual temperature
is reached (or greater than the set temperatures of clean
mode recipe (default 250 F for both the platen and grill)).
A 5 second repeating beep pattern is sounded.
5. Press the ENTER key
again, the heater’s control for the
platen and grill are turned o and the display shows the
message “CLEANING” with ashing in the second line.
6. Press the ENTER key again to exit the CLEAN MODE. The
display shows the message “STANDBY” in the rst line.
The control transitions to “STANDBY MODE” and preheats
to idle condition.
PLATEN SET:
This function allows the platen to be moved up or down
once it is parallel to the grill surface. Values range from –160
to +160.
OPERATION continued
EXTENDED TIME:
This option will add 6, 4 and 2 seconds to the time of the next
three cooks respectively if the grill has had no activity for
5 minutes. Provided the temperature is not 25°F above set
temperature for either the grill or the platen.
INSTANT ON TIME:
This can be set in the range of 00:00 to 00:40. Instant on will
turn on the heat zone(s) as soon as a cook cycle starts.
START DELAY:
This number is how long the operator must hold the GREEN
(‘CANCEL/RAISE’) and BLACK buttons to start a cooking cycle
for 2-sided recipes only. There will be one beep when the
cook is started and another beep when the START DELAY
time is reached. If the GREEN (‘CANCEL/RAISE’) and BLACK
buttons are released before that time the cook will be
canceled. If Yes is toggled press enter to allow the user to
pick from 1 to 5 seconds in 0.5 second increments using
and .
Daily Cleaning:
Warning: The upper platen surface and edges are very hot! To prevent burn injuries, use extreme caution when wiping
down release sheets and platen edges.
front trough. Then, squeegee the grease into the buckets
on either side. Do not use the scraper for this step.
4. Use a clean, damp cloth to clean back splash and
bullnose areas as needed during operation.
Note: To increase life of release material sheets, wipe them
down with a folded clean, damp cloth at least four times
during each hour of operation.