Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
119303-01A
5
PRODUCT
IDENTIFICATION
Figure 1 - Log Base Assembly
Log Set
Base
Assembly
Front
Burner
Rear
Burner
Top Louver
Assembly
Fireplace
Hood
Bottom Louver
Assembly
Screen
Assembly
Top Outer
Casing
Figure 2 - Fireplace
UNPACKING
CAUTION: Do not remove the
1. With utility knife, cut the carton all the way
around above the staples on the bottom tray.
Lift the carton off the heater. Remove packing.
Note: The hood is located in the packing on
the right hand side of the heater front. Lift the
heater off the bottom tray.
Blower
Assembly
2. Locate two screws above top corners of the
replace screen. Remove and discard these
screws. Lift replace screen up and pull out
to remove.
3. Remove protective packaging applied to logs,
log base assembly, and replace.
4. Remove replace hood from carton insert.
5. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought replace.
PRODUCT FEATURES
This vent-free replace is clean burning. It requires
no outside venting. There is no heat loss out a vent
or up a chimney. Heat is generated by both realistic
ames and glowing embers. When used without the
blower, the replace requires no electricity making
it ideal for emergency backup heat.
SAFETY DEVICE
This replace has a pilot with an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS/
pilot is a required feature for vent-free room heat-
ers. The ODS/pilot system shuts off the replace
if there is not enough fresh air.
This replace has a piezo ignitor. This system
requires no matches, batteries or other sources to
light replace.
BLOWER ASSEMBLY
This replace has a blower assembly. The blower
operates thermostatically and has a variable
speed control. The blower circulates heated air
from the replace into the room. Use of blower
is optional.
THERMOASTAT CONTROL
This replace has a thermostat sensing bulb and
control valve. The thermostat controls the heat
output and ame height. This maintains a consis-
tent room temperature. Even the lowest setting
provides realistic ames and glowing embers from
two burners. Selecting higher comfort settings al-
lows replace to run longer, producing greater heat
output. At lower comfort settings, the replace will
run less. This results in increased heating comfort.
This can also result in lower gas results.