Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
119303-01A
12
1. Frame in rough opening. Use dimensions shown
in Figure 13 for the rough opening. If installing
in a corner, use dimensions shown in Figure 14
for the rough opening. The height is 33" which
is the same as the wall opening above.
2. If using blower, install and properly ground
GA3555, three-prong 120 volt electrical out-
let, in replace. Follow instructions included
in kit.
3. Install gas piping into replace location. This
installation includes an approved exible gas
line (if allowed by local codes) after the equip-
ment shutoff valve. The exible gas line must
be the last item installed on the gas piping. See
Installing Gas Piping to Fireplace Location,
page 13.
4. Carefully set replace in front of rough opening
with back of replace inside wall opening.
5. Carefully insert replace into rough opening.
6. Attach exible gas line to gas supply. See Con-
necting Fireplace to Gas Supply, page 14.
7. Attach replace to wall studs using nails or
wood screws through holes in nailing ange
(see Figure 15).
8. Check all gas connections for leaks. See
Checking Gas Connections, page 15.
INSTALLATION
Continued
Figure 13 - Rough Opening for Installing
in Wall
Figure 14 - Rough Opening for Installing
in Corner
35
1
/
2
"
17
3
/
4
"
33"
39
3
/
8"
27
7
/
8"
55
5
/
8"
35
1
/
2"
Figure 15 - Attaching Fireplace to Wall
Studs
Nailing
Flanges
Nails or Wood
Screws
9. Plug electrical cord into electrical outlet
installed in step 2.
10. Install trim after nal nishing and/or painting
of wall (see Figure 7, page 10).
Mantel Clearances for Built-In
Installation
If placing mantel above built-in replace, you must
meet minimum clearance between mantel shelf and
top of replace opening.
NOTICE: If your installation does
not meet the minimum clear-
ances shown, you must do one
-
• remove the mantel
minimum clearances shown in