Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
113111-01E 17
INSTALLATION
Continued
Figure 23 - Removing Log Base
Assembly From Fireplace
Branch
Support
Screen
Screen
Shipping
Screw
Shoulder
Screw
Flexible
Gas Line
Check your building codes for any special re-
quirements for locating equipment shutoff valve
to replaces.
Apply pipe joint sealant lightly to male NPT
threads. This will prevent excess sealant from
going into pipe. Excess sealant in pipe could result
in clogged replace valves.
Installation Items Needed
• Phillips screwdriver
• sealant (resistant to propane/LP gas, not pro-
vided)
1. To remove fireplace screen, remove two
screws that hold replace screen in place for
shipping. These screws are located near top of
screen. Discard screws. Lift replace screen
up and pull out to remove.
2. Remove screws that attach branch support
to replace (see Figure 23). Carefully lift up
branch support and remove from replace (see
Figure 23).
3. Route exible gas line included from replace
control to equipment shutoff valve through
side or rear access holes in outer casing.
-
-
4.
Apply pipe joint sealant lightly to male threads of
gas connector attached to exible gas line/equip-
ment shutoff valve (see Figure 24).
5. Check all gas connections for leaks. See
Checking Gas Connections, page 18.
6. Replace branch support back into replace.
Feed exible gas line into replace base area
while replacing branch support. Make sure
the entire exible gas line is in replace base
area. Reattach branch support to replace with
screws removed in step 2.
Figure 24 - Attaching Flexible Gas Line
to Equipment Shutoff Valve
Flexible Gas Line
from Fireplace Gas
Regulator Provided
with Fireplace
To Fireplace Gas
Regulator
Equipment Shutoff
Valve Provided by
Installer
To External Regulator
NATURAL
To Gas Supply