Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
21
USING THE ROTISSERIE
TO LIGHT THE ROTISSERIE BURNER:
The location of the rotis burner makes it more susceptible to strong wind conditions,more so than the
protected grill burners. For this reason you should avoid operating the rotis during windy conditions.
As an added safety feature we’ve equipped the burner with an automatic safety valve which will not
allow gas to flow to the rotis burner unless the following conditions are present with the knob on:
1.The safety valve button is pressed,and held down.
2.The safety valve thermocouple has been sufficiently heated to keep safety valve open.
Open the lid. Push and hold the ignition button. You’ll hear a snapping sound. Turn the control knob
to “HI”. Engage the safety valve button and continue to hold until the burner is lit. Once lit,turn control
knob to desired setting. If the burner does not light within 4 to 5 seconds, release the safety valve
button and turn the control knob to “OFF”and wait 5 minutes before trying again.
If relighting a hot burner,wait 5 minutes.
Never leave the control knob on if rotis is not in use.
Never light a grill burner under the rotis while rotisserie burner is lit.
MANUAL LIGHTING:
To manually light the rotisserie, place a
butane lighter near the tip of the thermo-
couple as shown in Fig.31. Turn the control
knob to “HI”.Hold the safety valve button in
for about 4 to 5 seconds or until the burner
remains lit. Once lit, turn control knob to
desired setting. If the burner does not light
within 4 or 5 seconds, release the safety
valve button and turn the control knob to
“OFF” and wait 5 minutes before trying
again.
WARNING:
Keep hands and face away from front of burner! STAND TO THE SIDE WHEN
LIGHTING.ONCE LIT MOVE HAND AWAY QUICKLY.
WARNING:
Electrical Grounding Instructions:This appliance (rotisserie motor) is equipped
with a three-prong (grounding) plug for your protection against shock hazard
and should be plugged directly into a properly grounded three-prong
receptacle.Do not cut or remove the grounding prong from this plug.
The Rotisserie motor must be electrically grounded in accordance with local codes or, in the absence
of local codes,with the National Electrical Code,ANSI/NFPA 70-1990. Keep the Rotisserie motor electric
cord away from the heated surfaces of the grill. When not in use,remove and store the motor in a dry
location.
Thermocouple
FIG.31