Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Cal Flame 2008 Owner’s Manual Page 7
LTR20081044, Rev. A
Installation / Assembly
Installing the Rotisserie
Attach the two brackets to the sides of the grill, one on
each side, using two screws as shown below.
Slide the rotis motor on one of the brackets as shown be-
low. The rotis motor will work on either side of the grill.
Remove the metal cap protecting the outlet that provides
power for the rotis motor. Plug in the motor cord and
screw on the retainer nut to keep the plug in place.
You will need a second person to help you to avoid
damaging the grill, the transformer, or your barbe-
cue island.
Before installing a grill or side burner in any island or cut
out, make sure that the opening is not bigger than the
outside frame of the grill unit. The grill should rest on
the lip of the frame. For drop-in accessories, adequate
cross ventilation must be designed into enclosure to en-
sure the drop-in grill or side burner does not become
overheated.
Pay careful attention to the location of gas lines. Gas
lines should be routed away from sources of heat and
should make as few bends as possible.
Check to see if gas line connections will be accessible
when grill is installed.
If gas line connections are not easily accessible •
when the grill is installed, support the grill above
counter level and attach the gas lines to the grill.
When the gas connections are made, slide the grill
into the cut out.
If gas line connections are accessible when the grill •
is installed, slide the grill into the cut out and then
attach the gas lines.
Be very careful not to kink gas lines when lowering the
grill or side burner into the cut out.
Keep your ngers away from where the grill will be sup-
ported on counter. Your ngers could become trapped
and serious injury could occur.
Check to make sure the grill is level and is supported
around the entire outside edge. If the grill is not level or
is unstable, use non-combustible shims under the out-
side lip to stabilize it.
Perform the leak test procedure as described earlier in
this manual.