Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Cal Flame 2008 Owner’s Manual Page 5
LTR20081044, Rev. A
Installation / Assembly
The grill unit must be used with the gas pressure regula-
tor. The regulator will control and maintain a uniform gas
pressure in the manifold. The burner orices have been
sized for the gas pressure delivered by the regulator.
WARNING: Attempting to operate the grill unit without
the gas regulator installed could cause an explosion and
possible death.
LP Gas Hook Up
An enclosure for an LP gas cylinder shall be vented by
openings at the level of the cylinder valve and at oor
level. The effectiveness of the openings for purposes of
ventilation shall be determined with the LP-gas supply
cylinder in place. This shall be accomplished in one of
the following manners:
One side of the enclosure shall be completely 1.
open.
Enclosures that have four sides, complete with a top 2.
and bottom:
At least two ventilation openings at cylinder a.
valve level shall be provided in the sidewall,
equally sized, spaced at 180º (3.14 rad), and
unobstructed. Each opening shall have a to-
tal free area of not less than 7.1 cm²/kg (one
square inch per pound) of stored fuel capacity,
and not less than a total free area of 64.5 cm²
(10 square inches).
Ventilation openings shall be provided at oor b.
level and shall have a total free area of not less
than 7.1 cm²/kg (one square inch per pound)
of stored fuel capacity and not less than a to-
tal free area of 64.5cm² (10 square inches). If
ventilation openings at oor level are in a side-
wall, there shall be at least two openings. The
bottom of the openings shall be at oor level
and the upper edge no more than 127 mm (5
inches) above the oor. The openings shall be
equally sized, spaced at 180º (3.14 rad) and un-
obstructed.
Every opening shall have minimum dimensions c.
so as to permit the entrance of a 3.2 mm (1/8
inch) diameter rod.
Transporting and Storing LP Gas
Transport only one cylinder at a time. Ensure the cylinder
is secured in an upright position with the control valve
turned off and the dust cap in place. Store cylinders out-
doors and out of reach of children. Do not store cylinders
in a building, garage, or any other enclosed area.
Installing the Transformer
All grills with electrical components such as lights or a
convection fan will require the transformer to be installed
and plugged in before you can use it. This needs to be
done before the grill is inserted in the barbecue island.
When the transformer is attached to the grill chassis,
use care in placing the grill in the island cutout to avoid
hitting the transformer.