Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 16 Cal Flame 2008 Owner’s Manual
LTR20081044, Rev. A
Appendix
Problem: Plugged orice
Solution: Unplug the orice as follows:
Remove cooking grills, ame tamer and grease tray.•
Remove burners from the bottom of the rebox by pulling the cotter pin from beneath the burner •
peg using a standard screwdriver or needle nose pliers.
Carefully lift each burner up and away from the gas orice.•
Remove the orice from the control valve.•
Gently clear any obstruction with a ne wire.•
Reinstall the orice, reinstall the burners over the orices, and seat each burner peg into position •
hole at the bottom ledge of the rebox.
Replace all cotter pins.•
Replace cooking components and grease collectors.•
If an obstruction is suspected in the control valve, contact your local Cal Flame dealer for assis-
tance.
Problem: Misalignment of Igniter on Burner
Solution: Check for proper position of the electrode tip, which should be pointing forward towards the front •
of the burner and free of grease to allow proper sparking.
The ignition wire should be connected rmly to the valve ignition device and electrode. Replace •
the ignition wire if it is frayed or cracked.
With the gas supply closed and all control knobs set to the off position, check each position igniter •
individually for the presence of a spark at the electrode. Push each knob in fully and rotate it about
1/4 turn to the left (counter-clockwise) until you hear a loud click. The trigger hitting the strike block
should produce a blue spark at the electrode tip. Return control knob to the off position before
checking the next igniter.
While the grill is still hot, wait for a minimum of ve minutes before commencing re-ignition. (This •
allows accumulated gas fumes to clear.) If all checks / corrections have been made and the gas
grill still fails to operate properly, contact your local Cal Flame dealer.
Problem: Flashback
Solution: When re occurs in and around the burner tubes, immediately turn off gas at its source and turn the
control knob clockwise to the ‘OFF’ position. Wait until the grill has cooled off and then clean the
burner tubes and burners as described on page of this manual.