Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 8 Cal Flame 2008 Owner’s Manual
LTR20081044, Rev. A
Installation / Assembly
Installing Side Burners
Assemble a 9.5 mm pipe nipple to the 9.5 mm pipe tee using Teon tape or pipe sealant. Use only sealant that 1.
is approved for use on LP gas.
Install the pipe tee assembly to the grill intake pipe. Tighten assembly and align the branch opening of the tee 2.
with the hole of the cabinet.
Connect the exible hose (male end) to the pipe tee.3.
Install and secure the side burner into the island by simply setting it in place.4.
Connect the female end of the exible hose to the side burner intake pipe.5.
Connect gas supply to the grill.6.
Check for gas leaks using soap water solution.7.
C
B
A
B
C
A
Connect the last open line to the side burner.
(Use gas rated tape seal on all connections)
Take the other end of "T" adapter with flexible hose attached
and connect to end of male fitting located underneath and at
the back of the grill. (Use gas rated tape seal on all
connections).
Open barbecue door. Install flexible hose with regulator to
gas source, then connect other end to "T" adapter.
Make sure to use gas rated tape seal when installing
adapter to insure proper seal.
Grill
Items included with barbecue
1) One 9.5 mm "T" adapter
2) Two 9.5 mm hose fittings
Regulator is NOT included with barbecue.
NOTE: You will need to use a gas rated
sealer on gas connectors that are not flared.
To gas source
9.5 mm fittings
From Grill
From Side Burner
"T" Adapter (9.5 mm threaded)
To side burner, located
underneath behind burner.
To grill, located
underneath and
behind grill